NAME
sane-magicolor - SANE backend for KONICA MINOLTA magicolor scanners
DESCRIPTION
The sane-magicolor backend supports KONICA MINOLTA magicolor scanners connected via USB or LAN. Currently, only the magicolor 1690MF device is supported, no other devices with the same scanning protocol are known.
SUPPORTED DEVICES
The following scanner should work with this backend:
Device Details
-----------------------------
Vendor: KONICA MINOLTA
Model: magicolor 1690MF
CONFIGURATION
This section describes the backend’s configuration file entries. The file is located at:
/etc/sane.d/magicolor.conf
For a proper setup, at least one of the following entries are needed:
net
autodiscovery
net [IP ADDRESS] [DEVICE-ID]
usb
usb [VENDOR-ID] [DEVICE-ID]
FILES
/etc/sane.d/magicolor.conf
The backend configuration file
/usr/lib/x86_64-linux-gnu/sane/libsane-magicolor.a
The static library implementing this backend.
/usr/lib/x86_64-linux-gnu/sane/libsane-magicolor.so
The shared library implementing this backend (present on systems that support dynamic loading).
ENVIRONMENT
SANE_CONFIG_DIR
This environment variable specifies the list of directories that may contain the configuration file. Under UNIX, the directories are separated by a colon (’:’), under OS/2, they are separated by a semi-colon (’;’). If this variable is not set, the configuration file is searched in two default directories: first, the current working directory (".") and then in /etc/sane.d. If the value of the environment variable ends with the directory separator character, then the default directories are searched after the explicitly specified directories. For example, setting SANE_CONFIG_DIR to "/tmp/config:" would result in directories "/tmp/config", ".", and "/etc/sane.d" being searched (in this order).
SANE_DEBUG_MAGICOLOR
If the library was compiled with debug support enabled, this environment variable controls the debug level for this backend. Higher debug levels increase the verbosity of the output.
Example: export SANE_DEBUG_MAGICOLOR=127
To obtain debug messages from the backend, set this environment variable before calling your favorite frontend (e.g. xscanimage).
Example: SANE_DEBUG_MAGICOLOR=65 xscanimage
KNOWN BUGS AND RESTRICTIONS
Large color scans may sometimes timeout due to unknown reasons (the scanner simply stops returning data)
Cancelling large scans may lock up the scanner.
SEE ALSO
sane(7),
http://wiki.kainhofer.com/hardware/magicolor_scan
AUTHOR
Reinhold Kainhofer <reinhold [AT] kainhofer.com>