NAME
bfe — Broadcom BCM4401 Ethernet Device Driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file:
device
miibus
device bfe
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
if_bfe_load="YES"
DESCRIPTION
The bfe driver provides support for Broadcom BCM4401 based Fast Ethernet adapters.
The bfe driver supports the following media types:
autoselect
Enable autoselection of the media type and options.
10baseT/UTP
Set 10Mbps operation.
100baseTX
Set 100Mbps (Fast Ethernet) operation.
The bfe driver supports the following media options:
full-duplex
Set full duplex operation.
For further information on configuring this device, see ifconfig(8).
DIAGNOSTICS
bfe%d: couldn’t map memory A fatal initialization error has occurred.
bfe%d: couldn’t map interrupt A fatal initialization error has occurred.
bfe%d: failed to allocate DMA resources There are not enough mbufs available for allocation.
bfe%d: watchdog timeout -- resetting The device has stopped responding to the network, or there is a problem with the network connection (cable).
SEE ALSO
altq(4), arp(4), miibus(4), netintro(4), ng_ether(4), ifconfig(8)
HISTORY
The bfe device driver first appeared in FreeBSD 5.1.
AUTHORS
The bfe device driver was written by Stuart Walsh and Duncan Barclay. This manual page was written by Stuart Walsh.
BSD July 16, 2005 BSD