NAME
powermust - Driver for Mustek PowerMust series UPS equipment
NOTE
This man page only documents the hardware-specific features of the powermust driver. For information about the core driver, see nutupsdrv(8).
SUPPORTED HARDWARE
The powermust driver is known to work with the following UPSes:
Maxxtro UPS
600VA
Mustek PowerMust 400VA Plus
Mustek PowerMust 600VA Plus
Mustek PowerMust 800VA Pro
Mustek PowerMust 1000VA Plus
Mustek PowerMust 1400VA Plus
Mustek PowerMust 2000VA USB
OnLite AQUA 50
Soyntec Sekury C 500
Soyntec Sekury C 800
Square One Power QP 1000
Tecnoware Easy Power 1200
Trust UPS 1000 Management PW-4105
It is also known to work with various models from Blazer, Energy Sistem and Fenton Technologies. It may also work with similar models from other manufacturers, but they haven’t been tested.
EXTRA ARGUMENTS
This driver does not support any extra settings in the ups.conf(5).
UPS COMMANDS
This driver
supports some extra commands (see upscmd(8)):
test.battery.start
Perform a (10 second) battery test
shutdown.return
Turn off the load and return when power is back
shutdown.stayoff
Turn off the load and remain off
shutdown.stop
Stop a shutdown in progress
load.on
Turn on the load immediately
load.off
Turn off the load immediately
reset.input.minmax
Reset minimum and maximum input voltage status
USER VARIABLES
The behavior of
the driver can be controlled by some user definable
variables (see upsrw(8)):
ups.delay.shutdown
Interval to wait after shutdown with delay command (seconds)
ups.delay.start
Interval to wait before (re)starting the load (seconds)
BUGS
No known bugs at the moment.
AUTHOR
Carlos Rodrigues <carlos.efr [AT] mail.pt>
SEE ALSO
The core
driver:
nutupsdrv(8)
Internet
resources:
The NUT (Network UPS Tools) home page:
http://www.networkupstools.org/